Get a pack of two high - quality brush drive belts designed for Hoover Starlight and Powerdrive vacuum cleaners. These belts are identified by Stokes Part No. V7014 and RDB08, and are equivalent to Anlin AV107, Qualtex PPP108, and Menalux DB12. They are a perfect fit for a wide range of Hoover models including the Convertable U1124, U1128, U5012, Starlight U2002, U2004, U2068, U2070, PowerDrive U5012, U5022, U5032, U6023, U6033, and Dial - a - Matic U6023. The belts have an unstretched width of 12mm and a diameter of 108mm. Each pack comes with two vacuum cleaner brush roller drive belts. To make these belts last longer, always check that the brush roller is free from hair and fluff. These belts are fully guaranteed and extremely easy to install. With over 25 years of experience supplying appliance parts to both trade and retail customers, you can shop with complete confidence.
Using these Hoover vacuum cleaner belts is easy. First, make sure your vacuum cleaner is turned off and unplugged. Open the compartment where the old belt is located. Remove the old belt carefully. Take one of the new belts from the pack and place it around the brush roller and the motor pulley. Ensure it's properly seated. Close the compartment. When using your vacuum cleaner, check the brush roller regularly. If you notice hair or fluff building up on it, stop the vacuum and clean the roller. This will stop the belt from wearing out too fast. As for maintenance, store the extra belt in a cool, dry place. If you ever have any problems with the belt, since it's fully guaranteed, you can reach out to us for assistance.
