Enhance the performance of your AEG, Whirlpool, Electrolux, or Zanussi front - loader with these top - notch carbon motor brushes. This set of 1 pair is designed to fit many models equipped with a Sole motor. Part No. UN12102, which is equivalent to multiple other part numbers such as BT421, RS84732, CAR89, 9894, 9894L, 9894WP, Whirlpool 481281719419, Indesit C00114885, and Electrolux, AEG 4006020152. These carbon brushes are a great replacement for many European front - loader motor brushes. The carbon dimensions are 38mm long, 4.8mm thick, and 13mm wide. The mounting holes are 24mm apart, with locating spikes 18.5mm apart. The mounting holes are 19mm from the front end of the brushholder, and the front locating spike is 9mm from the front of the brushholder. The brushholder has PA6.6 - GF on the bottom, and the carbon brush has L93MF7 printed on the side. It features 4.8mm spade terminals that protrude upwards and is suitable for models with the new type Sole 105982 / 124309 motor. Some compatible AEG models include LAV54600 (91400309200), LAV64600 (91400309000), and many more. With over 25 years of experience supplying appliance parts to both trade and retail, you can buy with confidence.
Using these carbon motor brushes is quite straightforward. First, make sure your washing machine is unplugged to avoid any electrical hazards. Locate the old motor brushes and carefully remove them. Then, take your new UN12102 carbon motor brushes and place them in the same position as the old ones. Ensure that the mounting holes and locating spikes align correctly. Once installed, plug your washing machine back in and test it. As for maintenance, it's a good idea to check the brushes every few months for any signs of wear. If you notice excessive wear or if the washing machine starts to make unusual noises, it might be time to replace the brushes again. Also, keep the area around the brushes clean to prevent dust and debris from affecting their performance.
