These top - notch motor carbon brushes come in a pair and are a great fit for various Ariston, Indesit, HomeMaker, Samsung, and New World washing machines. Part number is BT106, equivalent to genuine part no. 047317 and Qualtex part No. CAR73. They are used in many front - loading washing machines with Indesco motors from Ariston, Indesit, HomeMaker, and New World, and also suit some Asko and Samsung models. The brush holder body is 54mm long, equipped with 6.4mm spade terminals. The hole spacing is 24mm, and the locating pins are 15mm apart, with the front locating pin 15mm from the front of the brushholder. You might get brushes in black or brown housings at the time of purchase, and both are fully interchangeable. They're suitable for a wide range of models like AB1030CUK, AB1036TUK, etc. When you notice erratic spinning or no spin at all, it's likely time to replace these brushes. They're easy to install and come with a full guarantee. With over 25 years of experience supplying appliance parts to trade and retail, you can buy with confidence.
Using these carbon motor brushes is quite straightforward. First, make sure your washing machine is unplugged to avoid any electrical hazards. Open the washing machine where the old brushes are located. Remove the old brushes carefully. Then, install the new brushes in the same position as the old ones. Make sure the spade terminals fit properly. When it comes to maintenance, check the brushes regularly for signs of wear. If you notice excessive wear, replace them right away. Also, keep the area around the brushes clean to ensure smooth operation. If you have any issues during installation or use, don't hesitate to contact our customer service. And remember, these brushes come with a guarantee, so you can use them worry - free.
