These top - notch motor carbon brushes come in a pair and are designed to fit Simpson, Hoover, AEG, and Asko front - loading washing machines. The part numbers include BT101L, BT - 101L, BT_101L, and there are several alternative numbers like CAR50, 125790, etc. They are suitable for some imported front - loading washing machines from Asko, Bosch, Simpson, and Hoover, such as Hoover A3268 and many others that use an AEG Code 550045 motor or FHP UOZ112G70 motor with left - hand carbon brushes. The brush holder body is 46.2mm long with an 'L' stamped on top. It has offset mounting holes 16.5mm and 21mm from the front of the brushholder, locating pins 14mm apart and 10.9mm from the front, and 3.7mm spade terminals. The original brushes might be marked PA66. If you're unsure about compatibility, contact us with your model number before buying. When these brushes are worn out, you'll notice erratic spinning or no spin at all. They are easy to install and come with a full guarantee. We've been supplying appliance parts for over 25 years, so you can buy with confidence.
Using these carbon motor brushes is straightforward. First, make sure your washing machine is unplugged for safety. Then, open the access panel where the old brushes are located. Remove the old brushes carefully and replace them with these new ones. Align the brushes properly with the mounting holes and terminals. Once installed, close the access panel and plug the machine back in. When it comes to maintenance, it's a good idea to check the brushes every few months. Look for signs of excessive wear, like if they're getting too short or showing a lot of damage. If you notice any issues, replace them right away. Also, keep the area around the brushes clean from dust and debris. And remember, if you're not sure if these brushes are right for your washing machine, give us your model number before making a purchase.
