These top - notch carbon motor brushes (SEI part no. BT421) are a perfect fit for many models of AEG, Whirlpool, Electrolux, and Zanussi front - loaders with Sole motors. They're equivalent to several other part numbers like UN12102, RS84732, and more. Ideal for replacing European front - loader motor brushes, these carbon brushes have specific dimensions: 35.5mm long, 5mm thick, and 13mm wide. The mounting holes are 24mm apart, and the locating spikes are 18.5mm apart. The mounting holes are 19mm from the front end of the brushholder, and the front locating spike is 9mm from the front. The brushholder has PA6.6 - GF on the bottom, and the carbon brush has 0607 93MF7 printed on the side. With 4.8mm spade terminals on top, they suit models with the new type Sole 105982 / 124309 motor. Some compatible AEG models include LAV54600, LAV64600, etc. We've been in the appliance parts business for over 25 years, so you can buy with confidence.
Using these carbon motor brushes is quite straightforward. First, make sure your front - loader is turned off and unplugged to avoid any electrical hazards. Remove the old motor brushes carefully from your AEG, Whirlpool, Electrolux, or Zanussi front - loader. Then, place the new brushes in the same position as the old ones, aligning the mounting holes and locating spikes correctly. Ensure the 4.8mm spade terminals are properly connected. When it comes to maintenance, it's a good idea to check the brushes periodically for wear and tear. If you notice any significant damage or excessive wear, replace them promptly. Keep the brush area clean to prevent dust and debris from affecting the performance. Store the brushes in a dry place when not in use. With these simple steps, your front - loader will keep running smoothly.
