These top - notch carbon motor brushes are a perfect fit for AEG, Whirlpool, Electrolux, Zanussi, and Philco models equipped with a Sole motor. You'll get one pair of these essential components. The ASP part numbers are BT102, BT - 102, and BT_102, and they're similar to many other part numbers like BT421, UN12102, and more. These carbon brushes can effectively replace a wide range of European front - loader motor brushes. The carbon has specific dimensions: 32mm long, 5mm thick, and 12.5mm wide. The mounting holes are 24mm apart, and the locating spikes are 18.5mm apart. The mounting holes are 19mm from the front end of the brushholder, and the front locating spike is 9mm from the front of the brushholder. The brushholder is 45mm long. The brushholder has PA - GF on the bottom, and the carbon has L93MF7 written on the side. It comes with 4.8mm side - facing spade terminals and suits models with the new type Sole 105982 / 124309 motor. Some of the compatible AEG models include LAV54600, LAV64600, and many others. With over 25 years of experience supplying appliance parts to both trade and retail, you can buy with full confidence.
Using these carbon motor brushes is easy. First, make sure your washing machine is unplugged to avoid any electrical hazards. Then, carefully remove the old motor brushes from your machine. Take note of how they're installed so you can put the new ones in the same way. Insert the new carbon motor brushes into the brushholder and make sure they fit snugly. When it comes to maintenance, it's a good idea to check the brushes regularly for wear and tear. If you notice that the carbon is getting too short or if there's a lot of debris around the brushes, it might be time to clean or replace them. Also, keep the area around the brushholder clean to ensure the brushes work smoothly. And remember, if you're not sure about anything, it's always a good idea to consult a professional technician.
