This is a genuine Chef Jonah black plastic end piece for oven and grill handles. It has the part number A07325601. The dimensions are as follows: 44.7mm from front to back, 27mm in height, and 43mm in width. There are three mounting holes, with the outer holes 30mm apart and one in the center that goes all the way through. This handle end is suitable for the oven and grill handles of some Chef black and stainless - steel CFE and CFG models, including CFE532SB, CFE532WB, CFE533WB, CFE535WB, CFE536WB, CFE537WB, CFE547SB, CFE547WB, CFG501WB, CFG503WB, CFG504SB, CFG504WB, CFG505WB, CFG517SB, CFG517WB, and CLE527WB. This listing is for a single handle end. Since there are several similar - looking handle ends, it's crucial to check the dimensions as that's the main difference between them. If you're unsure about its suitability, just contact us with your model number, and we'll confirm it for you. With over 25 years of experience supplying appliance parts to both the trade and retail, you can buy with confidence.
Using this Chef Jonah handle end is easy. First, make sure your oven or grill is turned off and cooled down. Then, remove the old handle end from your appliance. Line up the three mounting holes on the new handle end with the corresponding holes on the handle. You can then attach it firmly. As for maintenance, you can clean it with a mild soapy solution and a soft cloth. Just avoid using abrasive cleaners that might damage the plastic. Remember, since there are similar - looking handle ends, always double - check the dimensions before installing. If you're not sure it's the right fit for your model, give us a call with your model number, and we'll help you out.
