Product Detail
This is a high-quality Simpson universal 1.35-meter dual inlet hose. It features a 3/4' straight nut & tail on one end and a 3/4' right-angled nut & tail on the other end. The genuine part number is 4055578829, W031H, and it replaces part numbers 0571200125, 0571200105, 0571200079. Similar to models like W031R, HC003, W031, and W032. The 1.35-meter by 10mm pressure hose comes with two 3/4' BSP nut & tails. The red nut & tails are designed for hot water use. It includes a tap washer and a stainless steel filter washer. This hose is suitable for all large, medium, and small washing machines that have inlet hoses screwed onto the rear, excluding commercial machines such as Maytag, Kleenmaid, and Speed Queen. It's the authentic hot water inlet hose for all Simpson Eziset, Enduro, and other Simpson top-loading washing machines with screw-on hoses. We've been providing appliance parts to the trade and retail for over 25 years, so you can buy with confidence.
Using this Simpson inlet hose is easy. First, make sure your washing machine is turned off and unplugged. Unscrew the old inlet hoses from the back of the machine and the water taps. Then, connect one end of the new hose to the water tap. The straight nut & tail end usually goes to the tap. Tighten it firmly but don't over - tighten to avoid damage. Next, connect the other end, the right - angled nut & tail end, to the back of your washing machine. Again, make sure it's secure. When using, always check for any leaks at the connections. If you notice a leak, turn off the water supply immediately and re - tighten the connections. For maintenance, every few months, you can remove the stainless steel filter washer and clean it under running water to prevent blockages. Also, check the hoses for any signs of wear and tear like cracks or bulges. If you find any issues, replace the hose right away. This hose is not for commercial machines, so don't use it with Maytag, Kleenmaid, or Speed Queen commercial models.
