This is a top - notch universal dryer ducting vent kit designed for through - wall venting. Part numbers include VT32, V/T32, and D461. It's a permanent vent solution for clothes dryers. The kit comes with installation instructions, making it moderately easy to install, though some special tools are needed. It features an outside louvre with self - closing flaps. These flaps prevent bad weather and insects from getting back into the vent. It can fit wall cavities up to 35cm thick and most brands of vent hoses. The kit includes screws, rawl plugs, and an adaptor that suits both 100mm and 75mm vent hoses. Note that the flange for the rear of the dryer and the vent hose are not included. But don't worry, a suitable universal kit is available, and if the link doesn't work, it's just due to temporary stock - out. We also offer other kits that can be used with this one. With over 25 years of experience in supplying appliance parts to both trade and retail, you can buy with confidence.
Using this through - wall vent kit is straightforward. First, read the installation instructions carefully. You'll need some special tools for the job. Check the thickness of your wall cavity - it should be up to 35cm thick. Connect the adaptor to the vent hose, making sure it fits well, whether it's a 100mm or 75mm hose. Then, install the outside louvre with self - closing flaps to keep the weather and insects out. Remember, the flange for the dryer rear and vent hose aren't in the kit, so you'll need to get them separately if you don't have them. When it comes to maintenance, regularly check the louvre flaps to ensure they close properly. Also, clean the vent hose and the kit parts every few months to prevent blockages. If you have any questions, don't hesitate to reach out to us. We've been in the business for over 25 years and are here to help.
