This is a high - quality door hinge assembly for Technika 90cm underbench ovens. Part numbers include 33180011, SE361, TE181 and others like 7.33180011, PA210040006, 3120886WS, ED300077. You can spot the Technika hinge as it has '29' stamped on the front. It's a perfect fit for many Technika underbench oven models such as T948SS - 3, TTDT910, and also suits some non - Technika models like Eurotec EUROFSG90, Parmco AR900. Over time, the pivot points on the hinge assembly may wear out, causing the oven door to not close properly. This listing offers a single hinge. If you're unsure if this part suits your oven, just contact us with your model number as there are similar - looking hinges. It's incredibly easy to install and comes with a full guarantee. We've been in the appliance parts business for over 25 years, so you can buy with confidence.
Using this Technika underbench oven door hinge is a breeze. First, make sure your oven is turned off and unplugged for safety. Gently remove the old hinge from the oven door and the oven body. Then, place the new hinge in the same position as the old one and secure it with the appropriate screws. When closing and opening the oven door, do it gently to avoid putting too much stress on the hinge. As for maintenance, periodically check the hinge for any signs of wear or looseness. If you notice the pivot points are getting stiff, you can apply a small amount of lubricant. Also, keep the hinge clean from any debris or food particles. If you're ever unsure about the installation or maintenance, don't hesitate to contact us.
