This is a high - quality 4 - piece male and female oven door hinge set from Omega and Smeg. The genuine part numbers are SE212, SE212A, and 691330361. It's suitable for various Smeg and Omega ovens, such as SA360X, SA360EB, SA388X, SE392, SA392EB, SA392NE, SA395X and possibly other models. The hinges have the number 43 stamped on the part that goes into the oven wall. They are installed using 2 recessed holes, one near the top and one at the bottom. Over time, the pivot points on the hinge assembly may wear out, leading to the oven door not closing properly. This listing includes a pair of right and left hinges, along with parts for the oven door and receptacles in the oven wall. We recommend replacing all parts at once. With over 25 years of experience supplying appliance parts to both trade and retail, you can buy with confidence.
Using these oven hinges is straightforward. First, make sure your oven is turned off and cooled down. Remove the old hinges by carefully detaching them from the oven door and the oven wall using the appropriate tools. Then, install the new hinges in the same position as the old ones, aligning them with the 2 recessed holes. Make sure the hinges fit snugly. When it comes to maintenance, it's a good idea to clean the hinges regularly with a mild detergent and a soft cloth. This will prevent dirt and grime from building up and causing the pivot points to wear out faster. Also, keep an eye on the door's closing mechanism. If you notice any issues like the door not closing properly, it might be a sign that the hinges need to be checked or replaced. Remember, it's best to replace all the hinge parts at the same time to ensure optimal performance.
