This is an idler pulley that's compatible with early - type Simpson Eziset, EziLoader, and Electrolux EziSensor dryers. Its part number is 0197300040. It can replace a variety of part numbers such as 1250125034, 1250125 - 03/4, 1250125 - 20/8, 1250125208, D014, D462, 4055688826, 8581250125037, and 8581250125128. This pulley fits Simpson Eziset, EziLoader, and some late - model dual - direction dryers from Westinghouse and Electrolux that use a wide belt. It also works well with many Electrolux condensor dryers. The diameter of this idler pulley is 58mm and the width is 27mm. Unlike the genuine idler pulley, this part doesn't have the fibre washer built into one side. It's easy to install and comes with a full guarantee. With over 25 years of experience in supplying appliance parts to both the trade and retail sectors, you can buy with confidence.
Using this idler pulley is straightforward. First, make sure your dryer is turned off and unplugged. Then, locate the old idler pulley in your dryer. Remove the old pulley by following the instructions in your dryer's manual. Once the old pulley is out, simply place this new pulley in its position. It's designed to fit easily, so you shouldn't have any trouble installing it. As for maintenance, it's a good idea to check the pulley regularly for any signs of wear and tear. If you notice any damage, replace it right away. Keep the pulley clean from lint and debris, as this can affect its performance. When it comes to safety, always remember to turn off the dryer and unplug it before any installation or maintenance work. With proper use and care, this pulley will serve you well for a long time.
