This is a drum rear support and filter spigot assembly that works with Simpson and Westinghouse dryers. Part No is UNI252, which replaces 0012377009, 0012377009K (currently only available as 0012377009K), and D228. It's designed for some newer Simpson and Westinghouse clothes dryers, fitting models like Simpson 39P500, 39S500, Sirocco, Eziset (early), Maxidry 1000S, 1000P, 1200S, 1200P series and more. The kit comes with a rear spigot assembly and a release plunger. It's moderately easy to install and fully guaranteed. Detailed fitting instructions can be provided upon request. This part isn't sold separately by the manufacturer, so you need to buy the whole kit. If you're not sure if it fits your dryer, contact us with your dryer's full model number before buying. With over 25 years of experience in supplying appliance parts to both trade and retail, you can shop with confidence.
Using this drum support and spigot kit is straightforward. First, make sure your dryer is unplugged to avoid any electrical hazards. Then, carefully remove the old drum support and spigot according to your dryer's manual. Next, install the new parts from the kit. The release plunger should be placed in the right position as per the detailed fitting instructions if you requested them. It's moderately easy to fit, but if you face any difficulties, don't hesitate to reach out to us. When it comes to maintenance, keep the parts clean and free from debris. Regularly check for any signs of wear and tear. If you notice anything unusual, contact us for advice. Before purchasing, always double - check the suitability with your dryer's full model number. And remember, this part is only available as a complete kit from the manufacturer, so make sure to buy the whole set.
